How To Replace Kitchen Faucet

Replacing a kitchen faucet is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Step 1: Gather Your Tools and Materials

Before you begin, you will need to gather the following tools and materials:

* New kitchen faucet * Adjustable wrench * Basin wrench * Teflon tape * Plumber's putty * Utility knife * Flashlight (optional)

Step 2: Turn Off the Water Supply

The first step is to turn off the water supply to the kitchen faucet. There are usually two shutoff valves located under the sink, one for hot water and one for cold water. Turn both valves clockwise to close them.

Step 3: Disconnect the Water Supply Lines

Once the water supply is turned off, you can disconnect the water supply lines from the faucet. Use an adjustable wrench to loosen the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this could damage the lines.

Step 4: Remove the Old Faucet

Once the water supply lines are disconnected, you can remove the old faucet. Use a basin wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can pull the faucet straight up to remove it.

Step 5: Clean the Faucet Mounting Surface

Before you install the new faucet, you should clean the faucet mounting surface. Use a damp cloth to wipe away any dirt or debris. You can also use a mild cleaner to remove any stubborn stains.

Step 6: Apply Plumber's Putty

Apply a bead of plumber's putty around the base of the new faucet. The plumber's putty will help to seal the faucet and prevent leaks.

Step 7: Install the New Faucet

Insert the new faucet into the mounting hole. Align the faucet so that the handle is in the desired position. Tighten the nuts that hold the faucet in place using a basin wrench. Do not overtighten the nuts.

Step 8: Reconnect the Water Supply Lines

Reconnect the water supply lines to the new faucet. Tighten the nuts that connect the lines to the faucet using an adjustable wrench. Be careful not to overtighten the nuts, as this could damage the lines.

Step 9: Turn On the Water Supply

Turn on the water supply to the kitchen faucet. Check for leaks around the base of the faucet and the water supply lines. If you find any leaks, tighten the nuts that connect the lines to the faucet.