Changing Out A Kitchen Sink Faucet

Replacing a kitchen sink faucet is a relatively simple plumbing project that most homeowners can complete in an afternoon. With a few basic tools and some patience, you can save yourself the cost of hiring a plumber. Here's a step-by-step guide to help you get the job done.

### What You'll Need

Before you start, gather the following tools and materials:

Adjustable wrench
Basin wrench
Phillips screwdriver
Flathead screwdriver
Pliers
New kitchen sink faucet
Plumber's putty
Teflon tape
Bucket

### Step 1: Turn Off the Water Supply

The first step is to turn off the water supply to your kitchen sink. This is typically done by turning the shut-off valves located under the sink. If your sink does not have shut-off valves, you will need to turn off the main water supply to your home.

### Step 2: Disconnect the Old Faucet

Once the water supply is turned off, you can begin disconnecting the old faucet. Use the adjustable wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can remove the faucet from the sink.

### Step 3: Clean the Sink

Before you install the new faucet, take a few minutes to clean the sink. This will help to ensure that the new faucet will fit properly and will not leak.

### Step 4: Apply Plumber's Putty

Apply a ring of plumber's putty around the base of the new faucet. This will help to seal the faucet and prevent leaks.

### Step 5: Install the New Faucet

Insert the new faucet into the sink and tighten the nuts until they are snug. Be careful not to overtighten the nuts, as this could damage the faucet.

### Step 6: Connect the Water Lines

Connect the water lines to the new faucet. Use the basin wrench to tighten the nuts that hold the lines in place. Be sure to use Teflon tape on the threads of the nuts to prevent leaks.

### Step 7: Turn On the Water Supply

Turn on the water supply to your kitchen sink and check for leaks. If there are any leaks, tighten the nuts on the water lines until the leaks stop.

### Step 8: Test the Faucet

Once the faucet is installed and there are no leaks, test it to make sure it is working properly. Turn on the water and check the flow of water from both the hot and cold taps. If the water flow is weak or uneven, adjust the handles on the faucet until the flow is satisfactory.

### Step 9: Enjoy Your New Faucet

Congratulations! You have now successfully replaced your kitchen sink faucet. Enjoy the convenience of your new faucet and the satisfaction of knowing that you did it yourself.