How To Put Handles On Kitchen Drawers

When replacing old handles or installing new ones on kitchen drawers, the process is relatively straightforward and can be completed in a few simple steps.

Step 1: Gather

Materials

New handles
Screwdriver (Phillips or flathead, depending on the handle type)
Measuring tape or ruler
Pencil or marking tool
Drill (optional, if creating new holes)
Drill bit (optional, if creating new holes)

Step 2: Measure and Mark

Determine the desired placement of the handles on the drawer fronts.
Use a measuring tape or ruler and a pencil to mark the center point for each handle.

Step 3: Create Holes (if necessary)

If the drawer fronts do not have pre-drilled holes for handles, you will need to create them.
Use a drill with the appropriate drill bit to create holes at the marked center points.

Step 4: Install Handles

Insert the screws through the back of the handle and into the holes on the drawer front.
Tighten the screws using a screwdriver until the handles are secure.

Step 5: Check Alignment and Adjust

Step back and check the alignment of the handles to ensure they are even and symmetrical.
Make any necessary adjustments to the screws or hole placement as needed.

Additional Tips:

For handles with multiple screws, tighten them evenly to avoid warping the drawer front.
Use a level to ensure the handles are installed horizontally or vertically, as desired.
If the screws are too long, they may protrude through the inside of the drawer. Trim any excess length before tightening.
Consider the size and style of the handles to complement the overall kitchen design.