How To Put In A Kitchen Faucet

Installing a kitchen faucet is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can easily replace your old faucet with a new one.

Step 1: Gather Your Tools and Materials

Before you begin, gather the following tools and materials:

Adjustable wrench
Phillips head screwdriver
Flat head screwdriver
Plumber's putty
New kitchen faucet
Basin wrench (optional)

Step 2: Turn Off the Water Supply

Locate the water supply valves under the sink and turn them off. If there are no valves, you will need to turn off the main water supply to your home.

Step 3: Disconnect the Old Faucet

Using the adjustable wrench, loosen the nuts that hold the faucet in place. Be careful not to overtighten the nuts, as this could damage the faucet.

Once the nuts are loose, you can disconnect the water lines from the faucet. Use the flat head screwdriver to loosen the compression nuts on the water lines.

Finally, lift the old faucet out of the sink.

Step 4: Prepare the New Faucet

Apply a bead of plumber's putty around the base of the new faucet. This will help to seal the faucet and prevent leaks.

Step 5: Install the New Faucet

Insert the new faucet into the sink hole. Make sure that the faucet is centered and that the handle is facing the correct direction.

Tighten the nuts that hold the faucet in place. Again, be careful not to overtighten the nuts.

Step 6: Connect the Water Lines

Connect the water lines to the new faucet. Make sure that the hot water line is connected to the hot water supply valve and the cold water line is connected to the cold water supply valve.

Tighten the compression nuts on the water lines. Be sure to tighten the nuts securely, but do not overtighten them.

Step 7: Turn On the Water Supply

Turn on the water supply valves under the sink. Check for leaks around the faucet. If there are any leaks, tighten the nuts or compression nuts until the leak stops.